Start by checking the pressure gauge on your boiler about once a month. Your heating manual gives the right pressure for your system, and most sit between one and two bar. If the needle has dropped into the red, the system needs topping up.
Turn the boiler off first. Some filling loops are built into the boiler, so follow its manual for the exact steps. Open the filling valve slowly and you should hear water flowing in as the needle rises. Watch the gauge the whole time, then close both filling taps fully. A tap left even slightly open can push the pressure too high.
Bleeding radiators can drop the pressure too, so check the gauge afterwards. If it keeps falling, there may be a leak. Look around the radiator and boiler valves while the system is cold, because heat can seal a small leak. A very small leak can dry before you see it, leaving only a faint residue. Leave loose or broken pipe joints alone unless you are trained.
A boiler that keeps losing pressure has a fault in one of its parts. Calling early saves you refilling it week after week while a leak carries on. At Derek Stuart Heating & Gas I fix boilers losing pressure across North Shields, and I will find the faulty part and put it right. Have a look at how I handle boiler repairs, then get in touch once the needle keeps falling.


